Calcined magnesite Introduction:
Calcined magnesite traditional methods are carried out in the shaft kiln, rotary kiln is also beneficial way. Vertical kilns and rotary kilns are burning mine on the block, with a long burning time, burning non-uniformity, affect activity, while the formation of environmental pollution, waste of resources. Dynamic calciner to solve the burning problems. Products: Dynamic calciner is crushed by the hot air of the calcined magnesite powder of a furnace. Mainly by the warm dryer, heat exchanger, calcination furnace, trap, heat and so on. Materials into the furnace after a few seconds can be achieved by rapid decomposition. As the powder material is calcined, the calcined material evenly, there is raw burning and over-burning, calcining temperature can be controlled accurately. How it works: a good grinding magnesite powder material or mud pie, into the feeder, dryer or warm-up, there calcination furnace waste heat produced by decomposition of magnesite for the dry heat of air, dried calcined magnesite into the furnace after the calcination, decomposition of magnesium oxide (calcined magnesite) discharged from the discharge port. Features: 1. Calcined material evenly and fully, to produce reactive magnesium oxide. (2) equipment system clean, environmentally friendly. 3 energy savings compared with the vertical kiln 20 to 30% 4. Easy to operate, high degree of automation. Specifications: Series in sets of specifications within the production: 10,000 tons, 20,000 tons, 50,000 tons, 100,000 tons, 150,000 tons, 200,000 tons. |
|
|
|
|
